BendixKing KSN 770 - Pilots Guide - Manual (Page 374)

KSN 765/770 Integrated Communication Navigation Display
D200802000009
REV 2 Jun 2014 15-101
Flight Management System (FMS)
Honeywell International Inc. Do not copy without express permission of Honeywell.
DELETING AND MODIFYING A HOLD
When a hold is in the active flight plan, pushing the HOLD bezel
softkey displays the MOD and EXIT bezel softkey labels, as shown
in Figure 15--93. Pushing the MOD bezel softkey displays the
Modify Parameters window, which permits the pilot to modify the leg
distance or time as necessary.
NOTE: The EXIT bezel softkey label is displayed when the
estimated time to the hold is less than 1 minute or the hold is
being flown. Exiting a hold is described later in this section.
Figure 15--93
Delete or Modify a Hold
NOTE: When a hold has been entered into the flight plan but is not
currently being flown, the DEL bezel softkey label is
displayed in 1R (not shown in Figure 15--93). Pushing the
DEL bezel softkey removes the selected hold from the flight
plan before the hold becomes active.
A hold can also be deleted when in flight plan edit mode. Pushing the
DEL bezel softkey when the hold waypoint is highlighted deletes only
the hold and not the hold and waypoint at the same time.