BendixKing KSN 770 - Pilots Guide - Manual (Page 343)

KSN 765/770 Integrated Communication Navigation Display
D200802000009
REV 2 Jun 2014
Flight Management System (FMS)
15-70
Honeywell International Inc. Do not copy without express permission of Honeywell.
Direct--To and Nearest Function
The FMS provides the ability to use Direct--To to go
direct to any waypoint. To perform a Direct--To, push the
Direct--To bezel key . When pushed, the DIRECT TO
pop--up window, shown in Figure 15--66, is displayed.
Figure 15--66
Direct--To Pop--Up Window
The DIRECT TO pop--up window defaults to display flight plan
waypoints and the FPL bezel softkey label is active (in header and in
1R).
A waypoint is chosen from the list using the joystick knob or
touchscreen to highlight the desired Direct--To waypoint. When the
desired Direct--To waypoint is highlighted, the Direct--To is initiated by
pushing in the joystick knob or by double tapping the waypoint on the
touchscreen.
NOTE: Anytime a Direct--To is performed, the FMS display is
automatically displayed, even if the Direct--To was performed
while on another screen (i.e., NAV MAP or WX page).
Previous waypoints, nearest airports, nearest NAVAIDs and nearest
intersections can also be displayed in the nearest waypoint list. Pushing
the bezel softkey at 1R toggles through nearest waypoint groups in the
following order:
Flight Plan Waypoint  Previous Waypoints  Airports 
NAVAIDs  Intersections  Repeat