BendixKing KSN 770 - Pilots Guide - Manual (Page 231)

KSN 765/770 Integrated Communication Navigation Display
D200802000009
REV 2 Jun 2014 10-41
Datalink Weather View
Honeywell International Inc. Do not copy without express permission of Honeywell.
Table 10--8 (cont)
Control State Annunciators
Annunciator Description
Listening Only The KSN 765/770 is in listen--only mode.
This means that a different KSN 765/770 is
controlling the XM receiver, but this unit still
displays any weather product that is
received. Initializing the XM unit and
responding to errors is the responsibility of
the other KSN 765/770, and this unit is only
passively listening.
Configuring The XM unit is configured to send certain
periodic messages (such as signal quality
and time).
Tuning Searching for the satellite signal and tuning
to the correct frequency for the weather
products.
Validating -- x Validating the content channels for the
weather products. There are 11 content
channels that are used for the XM weather
products, so each one is individually
validated.
Validating -- Done The validation of the content channels is
complete.
Saving Config Periodically, the unit configuration is saved
(such as subscription data) and reboots.
This is done automatically and is synced by
XM such that no weather data products are
lost during the cycling.
DESCRIPTIVE MESSAGES
The following are two types of descriptive messages that are displayed
in the XM receiver status pop--up box:
D
Operational
D
Error.
Only one descriptive message is displayed at a time, with error
messages taking precedence over operational messages.