BendixKing KSN 770 - Pilots Guide - Manual (Page 369)

KSN 765/770 Integrated Communication Navigation Display
D200802000009
REV 2 Jun 2014
Flight Management System (FMS)
15-96
Honeywell International Inc. Do not copy without express permission of Honeywell.
D
Leg Dist -- The leg distance field permits the pilot to input the leg
distance in nautical miles. The FMS default value for leg distance is
3.3 NM below 14,000 feet MSL and 5.0 NM at or above 14,000 feet
MSL. The FMS uses the current altitude of the aircraft when
determining the altitude.
D
Speed -- The speed value field defaults to the current groundspeed
when the window is first displayed. The default speed does not
continuously update after the window is displayed. When the
waypoint has a published speed limit, the upper speed value is not
permitted to go higher than the published speed limit. When the
waypoint does not have a published speed limit, rotating the joystick
knob changes the values in 1--knot increments from 75 knots to
450 knots.
D
Entry -- The entry field displays the initial FMS calculated hold entry
when the Modify Parameters window is displayed. Possible
values are Direct, Parallel, or Teardrop. When turn direction or
course are modified, To Be Computed is displayed.
CREATING A HOLD AT A WAYPOINT
To create a hold at a waypoint, the joystick knob or touchscreen is first
used to select the waypoint that the hold is based on. For the example
flight plan, a hold is desired at the Ventura VOR (VTU). VTU is
highlighted in the waypoint list, as shown in Figure 15--87.
Figure 15--87
Creating a Hold