BendixKing KSN 770 - Pilots Guide - Manual (Page 353)

KSN 765/770 Integrated Communication Navigation Display
D200802000009
REV 2 Jun 2014
Flight Management System (FMS)
15-80
Honeywell International Inc. Do not copy without express permission of Honeywell.
Estimated Time En Route (ETE) -- The ETE from the current aircraft
position to the associated FMS waypoint is displayed in HH:MM format.
Performance calculations are based on actual air data when available
or a default value of 90 knots.
NOTE: ETE is displayed as dashes while on the ground.
Desired Track (DTK) -- The desired track for the waypoint segment is
displayed after the associated FMS waypoint.
Distance--To--Go (DTG) -- The distance--to--go from the current
aircraft position along the path shown to the associated FMS waypoint
is displayed in nautical miles (NM).
WAYPOINT LIST SYMBOLS
The FMS waypoint list contains symbols for procedures contained in
the flight plan. The following paragraphs describe the various symbols
displayed in the waypoint list.
Altitude Constraints
Altitude constraints are derived from the navigation database and
typically correspond to published altitude limitations for various points
in departure and approach procedures.
AT constraints are displayed with a small
line above and below the altitude.
AT or ABOVE constraints are displayed
with a small line below the altitude.
AT or BELOW constraints are displayed
with a small line above the altitude.
WINDOW constraints display both the upper and lower constraint.
Lower constraints are displayed to the right of the upper constraint.