Lightning detection view, Introduction – BendixKing KSN 770 - Pilots Guide User Manual
Page 250

KSN 765/770 Integrated Communication Navigation Display
D200802000009
REV 2 Jun 2014
12-1
Lightning Detection View
Honeywell International Inc. Do not copy without express permission of Honeywell.
12. Lightning Detection View
INTRODUCTION
This section describes the
lightning detection
(strikes)
view
and
control function, which lets the pilot control and display the WX--500
Stormscope
Series II weather mapping sensor. Lightning detection is
an optional feature and requires the installation of the WX--500.
The WX--500 detects electrical discharges associated with
thunderstorms within a 200 nautical miles (NM) radius of the aircraft.
The information is then sent to the KSN 765/770, which displays the
location of the electrical discharges on the lightning detection view or
as a map overlay.
NOTE: Refer to the WX--500 Stormscope
Series II user guide for
detailed information about storm mapping, operating, and
weather display interpretation of the WX--500 receiver.
CAUTION
THE USE OF THE LIGHTNING DETECTION VIEW IS FOR
LONG--RANGE
PLANNING
PURPOSES
ONLY,
NOT
SHORT--RANGE AVOIDANCE. DO NOT USE INFORMATION
PROVIDED TO PENETRATE WEATHER, THUNDERSTORMS,
CELLS, OR LINES OF CELLS. THE AERONAUTICAL
INFORMATION
MANUAL
RECOMMENDS
AVOIDING
THUNDERSTORMS IDENTIFIED AS SEVERE OR AVOIDING AN
INTENSE RADAR ECHO BY AT LEAST 20 MILES.