BendixKing KSN 770 - Pilots Guide - Manual (Page 383)

KSN 765/770 Integrated Communication Navigation Display
D200802000009
REV 2 Jun 2014
Flight Management System (FMS)
15-110
Honeywell International Inc. Do not copy without express permission of Honeywell.
The offset is removed by pushing the OFST bezel softkey and then the
CNCL bezel softkey. The same OFFSET FLIGHT PLAN window is
displayed, except when an offset is active, a CNCL bezel softkey label
is displayed, as shown in Figure 15--103. The FMS message OFFSET
REMOVED is displayed when the offset is canceled.
Figure 15--103
Removing an Offset
The offset distance can be modified by rotating the joystick knob when
the OFFSET FLIGHT PLAN window is displayed and pushing OK to
enter the modification.
Offsets are applied to the flight plan while in the en route, oceanic, or
remote phase of flight, however they are not available while flying the
following procedures or areas:
D
SIDs, STARs, and approaches
D
Patterns
D
Terminal areas (30 NM from the origin or 31 NM from the destination)
D
Polar regions.
NOTE: The OFST bezel softkey label on the 2/3 page is removed
from display when an offset is not permitted.
Offsets automatically cancel during the following conditions:
D
When the course changes greater than 90 degrees
D
On commencing SIDs, STARs, and approaches
D
On commencing intercepts.