BendixKing KSN 770 - Pilots Guide - Manual (Page 230)

KSN 765/770 Integrated Communication Navigation Display
D200802000009
REV 2 Jun 2014
Datalink Weather View
10-40
Honeywell International Inc. Do not copy without express permission of Honeywell.
Table 10--7 (cont)
Status Message Annunciators
Annunciator Description
Activation Required The XM receiver is indicating that the
receiver is not activated. Follow the
instructions to activate the receiver.
Antenna Failure The XM receiver is reporting that no antenna
is connected.
No Communications The XM receiver is not communicating with
the KSN 765/770. Continued failure to
power--up means there is an issue with
power to the receiver, a bad connection
between the KSN 765/770 and receiver, or a
bad connection between the KSN 765/770
and the XM receiver.
No Signal The XM receiver is indicating that no signal
is found.
CONTROL STATE
Table 10--8 lists the available control state annunciators that are
displayed in the XM receiver status pop--up box.
Table 10--8
Control State Annunciators
Annunciator Description
Retrying Doing a soft boot of the XM unit by sending
a power--down command and waiting
15 seconds.
Powering Up Initializing communications with the XM unit.
Operational Normal operation mode, where any data
products received is displayed.