Flight timers – BendixKing KSN 770 - Pilots Guide User Manual
Page 431

KSN 765/770 Integrated Communication Navigation Display
D200802000009
REV 2 Jun 2014
Flight Management System (FMS)
15-158
Honeywell International Inc. Do not copy without express permission of Honeywell.
Flight Timers
The flight timers page, shown in Figure 15--147, is displayed by pushing
the
TIMERS
touchscreen softkey. The flight timers page is used to
keep track of various flight times.
Figure 15--147
Flight Timers Page
The following paragraphs describe the flight timers page.
Flight Time -- The flight time is a counter of elapsed time since the unit
was powered on, manually reset, or has been in air. When configured
on the Menu, the Flight Time clock is automatically started after takeoff
and stopped on landing. When the
Flight Time RESET
touchscreen
softkey is pushed, the timer field (displayed in gray to the right of the
Flight Time
field) resets back to 00:00:00 and begins the flight timer
again.
Departure -- The departure field permits the pilot to keep track of the
departure time. The departure time is automatically registered after
takeoff
when the menu setting
is
enabled.
When the
Departure RESET
touchscreen softkey is pushed, the timer field
(displayed in gray to the right of the
Departure
field) resets back to
to the current Zulu time.
Direction -- The direction field permits the pilot to change the direction
of the stopwatch clock (displayed in 2R) from counting up or counting
down. When
UP
is selected, the stopwatch in 2R starts at 00:00:00
and counts up when the clock is started. When
DOWN
is selected, the
stopwatch in 2R counts down from the desired preset start value
(displayed in 3R). The
UP
and
DOWN
touchscreen softkeys are
alternated by pushing the 1R key.