H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 110)

13-3
To do... Use the command... Remarks
Enter Ethernet port
view interface interface-type
interface-number
Enter
Ethernet port
view or port
group view
Enter port group
view
port-group { manual
port-group-name |
aggregation
agg-id }
Required
Use either command.
Configurations made in Ethernet port
view will take effect on the current port
only; configurations made in port
group view will take effect on all ports
in the port group.
Enable BPDU tunneling for the
port(s)
bpdu-tunnel dot1q enable
Required
Disabled by default
z
BPDU tunneling must be enabled globally before the BPDU tunnel configuration for a port can take
effect.
z
The BPDU tunneling feature is incompatible with the GVRP feature, so these two features cannot
be enabled at the same time. For introduction to GVRP, refer to VLAN in H3C WX6103 Access
Controller Switch Interface Board Configuration Guide .
z
The BPDU tunneling feature is incompatible with the NTDP feature, so these two features cannot
be enabled at the same time. If you want to enable BPDU tunneling on a port, use the undo ntdp
enable command to disable NTDP first. For introduction to NTDP, refer to Cluster Management in
H3C WX6103 Access Controller Switch Interface Board Configuration Guide .
Configuring BPDU Transparent Transmission
Perform the following tasks to configure BPDU transparent transmission:
To do... Use the command... Remarks
Enter system view system-view —
Enable BPDU tunneling globally bpdu-tunnel dot1q enable
Optional
Enabled by default
Enter Ethernet port
view interface interface-type
interface-number
Enter
Ethernet port
view or port
group view
Enter port group
view
port-group { manual
port-group-name |
aggregation
agg-id }
Required
Use either command.
Configurations made in Ethernet port
view will take effect on the current port
only; configurations made in port
group view will take effect on all ports
in the port group.
Enable BPDU tunneling on the
port(s)
bpdu-tunnel dot1q enable
Required
Disabled by default
Disable STP on the port(s) stp disable
Required
Enabled by default
Enable BPDU tunneling for STP on
the port(s)
bpdu-tunnel dot1q stp
Required
Disabled by default