H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 592)

63-13
To do… Use the command… Remarks
Configure the destination port destination port port-number
Required
By default, no destination port
number is configured for a test
operation.
The destination port number must
be consistent with port number of
the listening service configured on
the NQA server.
Configure the source IP address of
a probe request in a test operation
source ip ip-address
Optional
By default, no source IP address is
specified.
The source IP address must be
that of an interface on the device
and the interface must be up.
Otherwise, the test will fail.
Configure common optional
parameters
Refer to Configuring Optional
Parameters Common to an NQA
Test Group Optional
Configuring the UDP-echo Test
You are not recommended to perform an NQA UDP test on ports from 1 to 1023 (known ports).
Otherwise, the NQA test will fail or the corresponding services of this port will be unavailable.
The UDP-echo test is used to test the roundtrip time of a UDP-echo packet from the client to the
specified server.
Configuration prerequisites
A UDP-echo test requires cooperation between the NQA server and the NQA client. The UDP listening
function needs to be configured on the NQA server before the UDP-echo test.
Configuring the UDP-echo test
Follow these steps to configure the UDP-echo test
To do… Use the command… Remarks
Enter system view system-view —
Enter NQA test group view
nqa entry admin-name
operation-tag
—
Configure the test type as
UDP-echo and enter test type view
type udp-echo Required