H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 340)

29-22
# Configure GigabitEthernet 0/0/3 to be a static router port.
[AC] interface GigabitEthernet 0/0/3
[AC-GigabitEthernet0/0/3] igmp-snooping static-router-port vlan 100
[AC-GigabitEthernet0/0/3] quit
4) Configure Switch A
# Enable IGMP Snooping globally.
<Switch A> system-view
[Switch A] igmp-snooping
[Switch A-igmp-snooping] quit
# Create VLAN 100, assign GigabitEthernet 0/0/1 and GigabitEthernet 0/0/2 to this VLAN, and enable
IGMP Snooping in the VLAN.
[Switch A] vlan 100
[Switch A-vlan100] port GigabitEthernet 0/0/1 GigabitEthernet 0/0/2
[Switch A-vlan100] igmp-snooping enable
[Switch A-vlan100] quit
5) Configure Switch B
# Enable IGMP Snooping globally.
<Switch B> system-view
[Switch B] igmp-snooping
[Switch B-igmp-snooping] quit
# Create VLAN 100, assign GigabitEthernet 0/0/1 through GigabitEthernet 0/0/5 to this VLAN, and
enable IGMP Snooping in the VLAN.
[Switch B] vlan 100
[Switch B-vlan100] port GigabitEthernet 0/0/1 to GigabitEthernet 0/0/5
[Switch B-vlan100] igmp-snooping enable
[Switch B-vlan100] quit
6) Verify the configuration
# View the detailed information about IGMP Snooping multicast groups in VLAN 100 on AC.
[AC] display igmp-snooping group vlan 100 verbose
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Port flags: D-Dynamic port, S-Static port, A-Aggregation port, C-Copy port
Subvlan flags: R-Real VLAN, C-Copy VLAN
Vlan(id):100.
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Router port(s):total 2 port.
GE0/0/1 (D) ( 00:01:30 )
GE0/0/3 (S)
IP group(s):the following ip group(s) match to one mac group.
IP group address:224.1.1.1
(0.0.0.0, 224.1.1.1):
Attribute: Host Port
Host port(s):total 1 port.
GE0/0/2 (D) ( 00:03:23 )