H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 585)

63-6
Follow these steps to configure the ICMP-echo test:
To do… Use the command… Remarks
Enter system view system-view —
Enter NQA test group view
nqa entry admin-name
operation-tag
—
Configure the test type as
ICMP-echo and enter test type
view
type icmp-echo Required
Configure the destination address
for a test operation
destination ip ip-address
Required
By default, no destination IP
address is configured for a test
operation.
Configure the size of probe
packets sent
data-size size
Optional
100 bytes by default.
Configure the string used to fill a
probe packet
data-fill string
Optional
The string of fill characters of a
probe packet is the string
corresponding with the ASCII code
00 to 09 by default.
Specify the IP address of an
interface as the source IP address
of an ICMP-echo request
source interface interface-type
interface-number
Optional
By default, no interface address is
specified as the source IP address
of ICMP probe requests.
If you use the source ip command
to configure the source IP address
of ICMP-echo probe requests, the
source interface
command is
invalid.
The interface specified by this
command must be up. Otherwise,
the probe will fail.
Configure the source IP address of
a probe request
source ip ip-address
Optional
By default, no source IP address is
specified.
If no source IP address is
specified, but the source interface
is specified, the IP address of the
source interface is taken as the
source IP address of ICMP probe
requests.
The source IP address must be
that of an interface on the device
and the interface must be up.
Otherwise, the probe will fail.
Configure the next hop IP address
for an ICMP-echo request
next-hop ip-address
Optional
By default, no next hop IP address
is configured.
Configure common optional
parameters
Refer to Configuring Optional
Parameters Common to an NQA
Test Group Optional