H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 216)

23-4
z
To configure this feature for an existing static route, simply associate the static route with a track
entry. For a non-existent static route, configure it and associate it with a Track entry.
z
If a static route needs route recursion, the associated track entry must monitor the nexthop of the
recursive route instead of that of the static route; otherwise, a valid route may be mistakenly
considered invalid.
Displaying and Maintaining Static Routes
To do… Use the command… Remarks
Display the current configuration
information
display current-configuration
Display the brief information of the IP
routing table
display ip routing-table
Display the detailed information of the
IP routing table display ip routing-table
verbose
View information of static routes
display ip routing-table
protocol static [ inactive |
verbose ]
Available in any view
Delete all the static routes delete static-routes all Available In system view
Configuration Example
Network requirements
The IP addresses and masks of the switches, access controller (AC), and hosts are shown in the
following figure. Static routes are required for interconnection between any two hosts.
Network diagram
Figure 23-1 Network diagram for static route configuration