H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 305)

27-13
Network diagram
Figure 27-4 Network diagram for DLDP configuration
Configuration procedure
1) Configuration on AC
# Enable DLDP on GigabitEthernet 0/0/25 and GigabitEthernet 0/0/26.
<AC> system-view
[AC] interface gigabitethernet 0/0/25
[AC-GigabitEthernet0/0/25] dldp enable
[AC-GigabitEthernet0/0/25] quit
[AC] interface gigabitethernet 1/0/26
[AC-GigabitEthernet0/0/26] dldp enable
[AC-GigabitEthernet0/0/26] quit
# Set the interval for sending Advertisement packets to 6 seconds.
[AC] dldp interval 6
# Set the DelayDown timer to 2 seconds.
[AC] dldp delaydown-timer 2
# Set the DLDP mode as enhanced mode.
[AC] dldp work-mode enhance
# Set the port shutdown mode as auto mode.
[AC] dldp unidirectional-shutdown auto
# Enable DLDP globally.
[AC] dldp enable
# Check the information about DLDP.
[AC] display dldp
DLDP global status : enable
DLDP interval : 6s
DLDP work-mode : enhance
DLDP authentication-mode : none
DLDP unidirectional-shutdown : auto
DLDP delaydown-timer : 2s
The number of enabled ports is 2.
Interface GigabitEthernet0/0/25