H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 37)

2-7
To do… Use the command… Remarks
Set the timeout time of the user
interface idle-timeout minutes
[ seconds ]
Optional
The default timeout time of a user
interface is 10 minutes.
With the timeout time being 10 minutes,
the connection to a user interface is
terminated if no operation is performed
in the user interface within 10 minutes.
You can use the idle-timeout 0
command to disable the timeout
function.
Note that if you configure to authenticate the users in the password mode, the command level available
to users logging in to the access controller switch interface board depends on both the
authentication-mode password command and the user privilege level level command, as listed in
Table 2-5 .
Table 2-5 Determine the command level when users logging in to the access controller switch interface
board are authenticated in the password mode
Scenario
Authentication mode User type Command
Command level
The user privilege level level command
not executed
Level 0
Password
(authentication-mode
password
)
VTY users
The user privilege level level command
already executed Determined by the
level
argument
Configuration Example
Network requirements
Assume that you are a level 3 Console user and want to perform the following configuration for Telnet
users logging in to VTY 0:
z
Authenticate users logging in to VTY 0 using the local password.
z
Set the local password to 123456 (in plain text).
z
Commands of level 2 are available to users logging in to VTY 0.
z
Telnet protocol is supported.
z
The screen can contain up to 30 lines.
z
The history command buffer can contain up to 20 commands.
z
The timeout time of VTY 0 is 6 minutes.
Network diagram
Figure 2-2 Network diagram for Telnet configuration