H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 600)

63-21
HTTP Test Configuration Example
Network requirements
Use the HTTP function to test the connection with a specified HTTP server and the time required to
obtain data from the HTTP server.
Network diagram
Figure 63-6 Network diagram for the HTTP test
Configuration procedure
# Create an HTTP test group and configure related test parameters.
<AC> system-view
[AC] nqa entry admin test
[AC-nqa-admin-test] type http
[AC-nqa-admin-test-http] destination ip 10.2.2.2
[AC-nqa-admin-test-http] operation get
[AC-nqa-admin-test-http] url /index.htm
[AC-nqa-admin-test-http] http-version v1.0
[AC-nqa-admin-test-http] quit
# Enable the HTTP test.
[AC] nqa schedule admin test start-time now lifetime forever
# Display results of an HTTP test.
[AC] display nqa result admin test
NQA entry(admin admin, tag test) test results:
Destination IP address: 10.2.2.2
Send operation times: 1 Receive response times: 1
Min/Max/Average round trip time: 64/64/64
Square-Sum of round trip time: 4096
Last succeeded probe time: 2007-03-27 13:40:36.2
Extend results:
Packet lost in test: 0%
Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to sequence error: 0
Failures due to internal error: 0
Failures due to other errors: 0
UDP-jitter Test Configuration Example
Network requirements
Use the NQA UDP-jitter function to test the delay jitter of packet transmission between AC and Switch.