H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 87)

9-10
# Enable GVRP on GigabitEthernet 0/0/1.
[Device-GigabitEthernet0/0/1] gvrp
[Device-GigabitEthernet0/0/1] quit
# Create VLAN 3 (a static VLAN).
[Device] vlan 3
3) Verify the configuration
# Display dynamic VLAN information on AC.
[AC] display vlan dynamic
No dynamic vlans exist!
# Display the VLANs allowed on GigabitEthernet 0/0/1.
[AC] display interface GigabitEthernet 0/0/1
GigabitEthernet0/0/1 current state: DOWN
IP Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 00e0-fc55-0010
Description: GigabitEthernet0/0/1 Interface
Loopback is not set
Media type is twisted pair
Port hardware type is 1000_BASE_T
Unknown-speed mode, unknown-duplex mode
Link speed type is autonegotiation, link duplex type is autonegotiation
Flow-control is not enabled
The Maximum Frame Length is 9212
Broadcast MAX-ratio: 100%
Unicast MAX-ratio: 100%
Multicast MAX-ratio: 100%
Allow jumbo frame to pass
PVID: 1
Mdi type: auto
Link delay is 0(sec)
Port link-type: trunk
VLAN passing : 1(default vlan)
VLAN permitted: 1(default vlan)
(Omitted)
The above output indicates that port GigabitEthernet 0/0/1 only allows packets of VLAN 1 to pass.
# Display dynamic VLAN information on Device.
[Device] display vlan dynamic
No dynamic vlans exist!
Device in this configuration example refers to a device that supports VLAN in a generic sense.