H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 444)

46-4
Configuring an SP Queue
Configuration Procedure
Follow these steps to configure SP queues:
To do… Use the command… Remarks
Enter system view system-view —
Enter port
view interface interface-type
interface-number
Enter port
view or
port group
view
Enter port
group view
port-group { manual
port-group-name | aggregation
agg-id }
Perform either of the two operations.
The configuration performed in Ethernet port
view applies to the current port only. The
configuration performed in port group view
applies to all the ports in the port group.
Configure SP queue
scheduling algorithm
qos sp
Required
By default, all the ports adopt the WRR queue
scheduling algorithm, with the weight values
assigned to queue 0 through queue 7 being
1, 2, 3, 4, 5, 9, 13, and 15.
Configuration Examples
Network requirements
Configure GigabitEthernet0/0/1 to adopt SP queue scheduling algorithm.
Configuration procedure
# Enter system view.
<Sysname> system-view
# Configure an SP queue for GigabitEthernet0/0/1 port.
[Sysname] interface GigabitEthernet 0/0/1
[Sysname-GigabitEthernet0/0/1] qos sp
Configuring a WRR Queue
By default, SP queue scheduling algorithm is adopted on all the ports. You can adopt WRR queue
scheduling algorithm as required.
Configuration Procedure
Follow these steps to configure WRR queues: