H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 668)

69-3
To do… Use the command… Remarks
Enter system view system-view —
Create a Track object and
associate it with the specified
Reaction entry of the NQA test
group
track track-entry-number nqa
entry admin-name
operation-tag
reaction item-num
Required
No Track object is created by
default.
When you configure a Track object, the specified NQA test group and Reaction entry can be
nonexistent. In this case, the status of the configured Track object is Invalid.
Configuring Collaboration Between the Track Module and the
Application Modules
Configuring Track-Static Routing Collaboration
You can check the validity of a static route in real time by establishing collaboration between Track and
static routing.
If you specify the next hop but not the egress interface when configuring a static route, you can
associate the static route with a Track object and thus check the validity of the static route according to
the status of the Track object.
z
If the status of the Track object is Positive, then the next hop of the static route is reachable, and
the configured static route is valid.
z
If the status of the Track object is Negative, then the next hop of the static route is unreachable,
and the configured static route is invalid.
Follow these steps to configure the Track-Static Routing collaboration:
To do… Use the command… Remarks
Enter system view system-view —
Configure the Track-Static Routing
collaboration, so as to check the
reachability of the next hop of the
static route
ip route-static dest-address { mask |
mask-length } next-hop-address track
track-entry-number [ preference
preference-value ] [ tag tag-value ] [ description
description-text ]
Required
Not configured by
default.