Yaskawa MP3200 Troubleshooting Manual - Manual (Page 206)

7.5 System Register Configuration and Error Status
Automatic Reception Status (Ethernet Communications)
7-80
Transmission Status
Error Status
Circuit
Number 8
CH3 Status SW25608 to SW25615 Same as CH1 status
CH4 Status SW25616 to SW25623 Same as CH1 status
CH5 Status SW25624 to SW25631 Same as CH1 status
CH6 Status SW25632 to SW25639 Same as CH1 status
CH7 Status SW25640 to SW25647 Same as CH1 status
CH8 Status SW25648 to SW25655 Same as CH1 status
CH9 Status SW25656 to SW25663 Same as CH1 status
CH10 Status SW25664 to SW25671 Same as CH1 status
Register Value Status Description
0 − Unused connection.
1 IDLE Standby mode for executing message functions.
2 WAIT Waiting to establish a connection.
3 CONNECT Ready to send and receive data.
Register Value Status Description
0 No error Normal
1 Socket creation error System error
2 Local port number error
Local port number setting error (The same address is
bound during disconnection of the TCP connection.)
3 Changing socket attribute error System error (for TCP)
4 Connection Error (M-SND)
Connection error (The connection was rejected by the
remote station when establishing a connection with an
unpassive open for TCP.)
5 Connection error (M-RCV) Connection error (With a passive open for TCP)
6 System error System error
7 TCP data send error
Data sending error (The remote station does not exist or
has not started when using TCP.)
8 UDP data send error Data sending error (for UDP)
9 TCP data receive error
Data reception error (The MP3000 received a request to
disconnect from the remote station for TCP.)
10 UDP data receive error Data reception error (for UDP)
11 Changing socket option error System error
12 Data conversion error Data conversion error
Continued from previous page.
Circuit Number Name Register Addresses Name