Nortel Networks 1000 - Manual (Page 101)

QPC441 3-Port Extender cards 101
QPC43 Peripheral Signaling card
Options (minimum vintage N) Plug location
NT5D21 Core/Network module F13
NT8D35 Network module
QPC414 Network card
Application
Pin connection
J3/S2 and J4/S1
T-1 facilities (including PRI/DTI),* channel service
unit connect pins 1 and 2
(pin 1 is next to the white dot)
Note: Possible jumper locations for vintage B (for different styles/series):
J3—E11 or H11
J4—H17 or E7
S1 and S2—E33
Note: Possible jumper locations for vintage A (for different styles/series). These cards can only be
used in the option A setting:
J3—H5 or E11
J4—H17 or E7
S1 and S2—E33
Note: Connectors and loop relations:
Even loop: J1 faceplate connector, jumper at J4 or S1
Odd loop: J2 faceplate connector, jumper at J3 or S2
QPC441 3-Port Extender cards
For CS 1000M SGand MG systems, QPC441 vintage F or later must be
used in all modules.
Table 42
QPC441 3PE card installed in the NT4N41CP PII Core Net modules
Jumper Settings: Set Jumper RN27 at E35 to "A".
Switch Settings
Module D20 switch position
NT4N41 CP Core/Net modules only 1 2 3 4 5 6 7 8
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 02.06 Standard
27 August 2008
Copyright © 2003-2008 Nortel Networks
.