Nortel Networks 1000 - Manual (Page 298)

298 NT5D33 and NT5D34 Lineside E1 Interface cards
Incoming call CONNECTED SEND – This is the value that the LEI
sends to the CPE to indicate that it has seen and recognized the off hook
indication sent by the CPE. The call is considered fully connected at this
point. This value is required.
Incoming call (Far-end) DISCONNECT SEND – This is the value that
the LEI sends to indicate that the far-end has released the call. This value
is required.
Incoming call (CPE) DISCONNECT RECEIVE – This is the value that the
LEI expects to see from the CPE when the customer equipment wishes to
end the call. This value is required.
Outgoing call SEIZE RECEIVE –This is the value that the LEI expects to
see when the CPE goes to an off hook condition and wishes to initiate a
call. This value is required.
Outgoing call SEIZE ACK SEND –This is the value that the LEI sends
to indicate that the seized condition has been noted and the M-1 is ready
for dial digits. This value can be set to N if it is not required such as in a
loop start case.
Outgoing call DIAL MAKE RECEIVE – This is the value that the LEI
expects to see from the CPE during the make part of the digit. This value
is required.
Outgoing call DIAL BREAK RECEIVE – This is the value that the LEI
expects to see from the CPE during the break part of the digit. This value
is required.
Outgoing call ANSWERED SEND – This is the value that the LEI sends
to indicate that the far-end has answered the call. This value is required.
Outgoing call (CPE) DISCONNECT RECEIVE – This is the value that the
LEI expects to see from the CPE when the customer equipment wishes to
end the call. This value is required.
Outgoing call (Far-end) DISCONNECT SEND – This is the value that
the LEI sends to indicate that the far-end has released the call. This value
is required.
Disconnect Time – This is the number of milliseconds that the LEI sends
the disconnect signal to the CPE before reverting to the idle state. If the
CPE reverts to a connected state during this time, it is ignored. This value
is only used when disconnect supervision is available and is needed
for the signaling type in use. It is used when the far-end initiates the
disconnect. For loop start cases, this value is not used.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 02.06 Standard
27 August 2008
Copyright © 2003-2008 Nortel Networks
.