Nortel Networks 1000 - Manual (Page 66)

66 Circuit card installation
Figure 16
Installing the circuit card in the card cage
7 Insert the card into the card aligning guides in the card cage.
Gently push the card into the slot until you feel resistance. The
tip of the locking device must be behind the edge of the card
cage (see
Figure 16 "Installing the circuit card in the card cage"
(page 66) ).
8 Lock the card into position by simultaneously pushing the ends
of the locking devices against the faceplate.
Note: When IPE cards are installed, the red LED on the
faceplate remains lit for two to five seconds as a self-test runs.
If the self-test is completed successfully, the LED flashes
three times and remains lit until the card is configured and
enabled in software, then the LED goes out. If the LED does
not follow the pattern described or operates in any other
manner (such as continually flashing or remaining weakly lit),
replace the card.
9 If there is an enable/disable switch, set it to Enb.
Note: Do not enable the switch on an NT8D04 Superloop
Network card or QPC414 Network card until network loop
cables are installed.
10 If you are adding a voice, conference, or tone and digit loop,
press the manual initialize (Man Int) button on the NT5D03 or the
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 02.06 Standard
27 August 2008
Copyright © 2003-2008 Nortel Networks
.