Nortel Networks 1000 - Manual (Page 995)

Applications 995
the three remaining serial ports (ports 2, 3, and 4), on a single DB-25
connector. An adapter cable must be used to connect to standard
RS-232-C peripherals. Cables that are applicable to the QSDI card are:
• SDI male-to-female flat cables (internal module use only)
— NT8D82
— QCAD290
Note: This cable is available in different lengths. Refer to
Equipment Identification (NN43001-254) for more information
— QCAD42
• SDI male-to-male round cables (external use only)
— NT8D95
•
SDI to I/O cables (system options use only)
— NT8D82
Note: This cable is available in different lengths. Refer to Equipment
Identification (NN43001-254) for more information
• SDI multiple-port cable (internal system options use only)
— NT8D90
•
SDI I/O to DTE/DCE cables (system options use only)
— NT8D95
Note: This cable is available in different lengths. Refer to Equipment
Identification (NN43001-254) for more information
• SID Multiple-port cable (system options use only)
— NT8D96
Figure 287 "QPC841 QSDI card cabling" (page 996) shows the QPC841
card and the cables listed above in a standard configuration.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 02.06 Standard
27 August 2008
Copyright © 2003-2008 Nortel Networks
.