Nortel Networks 1000 - Manual (Page 110)

110 NT1R20 Off-Premise Station Analog Line card
The faceplate of the card is equipped with a red LED. See Figure 20 "OPS
analog line card - faceplate" (page 111) . When an OPS analog line card
is installed, the LED remains lit for two to five seconds while the self-test
runs. If the self-test is completed successfully, the LED flashes three times
and remains lit. When the card is configured and enabled in software;
then the LED goes out. If the LED continues to flash or remains weakly
lit, replace the card.
Self Test
The faceplate of the NT1R20 OPS analog line card is equipped with a red
LED. When an OPS analog line card is installed, the LED remains lit for
two to five seconds while the self-test runs. If the self-test is completed
successfully, the LED flashes three times and remains lit. When the card
is configured and enabled in software; then the LED goes out. If the LED
continues to flash or remains weakly lit, replace the card. See
Figure 20
"OPS analog line card - faceplate" (page 111) .
The faceplate of the card is equipped with a red, light-emitting diode
(LED). When an OPS analog line card is installed, the LED remains lit for
two to five seconds while the self-test runs. If the self-test is completed
successfully, the LED flashes (off/on) three times and remains lit until the
card is configured and enabled in software, then the LED goes out.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 02.06 Standard
27 August 2008
Copyright © 2003-2008 Nortel Networks
.