Nortel Networks 1000 - Manual (Page 591)

Operation 591
In the pulse start mode, a start pulse activates playback of a message that
continues until completion. The announcement machine ignores all other
start pulses that might occur until the message is complete.
In the level start mode, the start signal is a "level" rather than a pulse. The
leading edge of the start signal initiates message playback that continues
until either the trailing edge of the start signal occurs or the end of the
message is reached. A message that is terminated by the trailing edge of
a level start signal is immediately reset and ready for playback again.
Call routing to RAN trunks
The CS 1000 software controls recorded announcement machines. These
programs detect the calls to be intercepted, determine the type of intercept
treatment required (for example, overflow, attendant, announcement),
queue the intercept, and provide ringback tone to the calling party. At the
proper time, an intercepted call is connected to the appropriate RAN trunk.
programs in the Meridian 1 control recorded announcement machines.
These programs detect the calls to be intercepted, determine the type of
intercept treatment required (overflow, attendant, announcement, etc.),
queue the intercept, and provide ringback tone to the calling party. At the
proper time, an intercepted call is connected to the appropriate RAN trunk.
The software in the CS 1000 controls recorded announcement machines.
These programs detect the calls to be intercepted, determine the
type of intercept treatment required (for example, overflow, attendant,
announcement), queue the intercept, and provide ringback tone to the
calling party. At the proper time, an intercepted call is connected to the
appropriate RAN trunk.
Programming RAN trunks
The type of intercept and the RAN trunk parameters are defined in the
Trunk Data Block LD 14, Customer Data Block LD 15, and Route Data
Block LD 16 programs.
The Trunk Data Block and Route Data Block programs specify the
following:
• the RAN trunk
• the type of announcement machine
•
the number of repetitions of announcements before a forced
disconnect (all calls) or an attendant intercept is initiated (CCSA/DID
calls only)
•
the point at which the trunk may be connected to the announcement
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 02.06 Standard
27 August 2008
Copyright © 2003-2008 Nortel Networks
.