Jumper strap settings – Nortel Networks 1000 User Manual

Page 609

Advertising

Configuration

609

Table 226
Trunk types - termination impedance and balance network (NT8D14BA, NT8D14BB) (cont’d.)

Balance network for loop lengths (Note 2)

Trunk types

Terminating
impedance
(Note 1)

0–915 m

(0–3000 ft)

915–1524 m

(3000–5000 ft)

> 1524 m

(> 5000 ft)

RAN: continuous
operation mode

600 or 900
ohms

600 or 900 ohms

N/A

Paging

600 ohms

N/A

Note 1: The terminating impedance of each trunk unit is software selectable in LD 14 and should
match the nominal impedance of the connecting equipment.

Note 2: The balance network of each trunk unit is software selectable between resistive 600 or
900 ohms or 3COM and jumper selectable between 3COM and 3CM2. Jumper selection for
3COM/3CM2 restriction does not apply to NT8D14BB.

The trunk type for each unit on the card as well as its terminating
impedance and balance network configuration is selected by software
service change entries at the system terminal and by jumper strap settings
on the card.

NT8D14BB (Release 10 and higher) has a reduced jumper strap setting
on the card. There are only three jumpers, J1.X, J2.X, and J3.X per
channel.

Table 229 "Jumper strap settings - factory standard (NT8D14BA,

NT8D14BB)" (page 614)

Table 230 "Jumper strap settings - extended

range (NT8D14BA, NT8D14BB, NT8D14BB Release 10 and up)" (page
615)

, and

Table 231 "Trunk types - termination impedance and balance

network (NT8D14BA, NT8D14BB)" (page 615)

show the functionality of

these 3 jumpers.

NT8D14BB (Release 10 and higher) has a reduced jumper strap setting
on the card. There are only three jumpers, J1.X, J2.X, and J3.X on each
channel.

Table 229 "Jumper strap settings - factory standard (NT8D14BA,