Nortel Networks 1000 - Manual (Page 364)

364 NT5K21 XMFC/MFE card
XMFE sender and receiver specifications
Table 153 "XMFE sender specifications" (page 364) and Table 154
"XMFE receiver specifications" (page 364) provide the operating
requirements for the XMFC/MFE card when it is configured as an XMFE
card. These requirements conform to French Socotel specifications
ST/PAA/CLC/CER/692.
Table 153
XMFE sender specifications
Forward frequencies in OG mode: 700, 900, 1100, 1300, 1500 Hz
Forward frequencies in IC mode: 1900 Hz
Frequency tolerance: +/- 0.25% from nominal
Power level at each frequency: Selectable: 1 of 16 levels
Level tolerance: +/- 1.0 dB
Harmonic Distortion and Intermodulation: 35 dB below level of 1 signaling frequency
Time interval between start of 2 tones: 125 usec.
Time interval between stop of 2 tones: 125 usec.
Table 154
XMFE receiver specifications
Input sensitivity:
accepted:
rejected:
rejected:
rejected:
-4 dBm to -35 dBm +/- 10 Hz of nominal
-42 dBm signals
-4 dBmoutside 500-1900 Hz
-40 dBmsingle/multiple sine wave in 500-1900 Hz
Bandwidth:
accepted:
fc +/- 20 Hz
Amplitude twist:
accepted:
difference of 9 dB between frequency pair
Operating time: < 64 msec.
Release time: < 64 msec.
Tone Interrupt causing no
release:
< 8 msec. Receiver on, tone missing
Longest Input tone ignored: < 8 msec. Combination of valid frequencies
Longest control tone ignored: < 15 msec.Control Frequency only
Noise rejection: S/N > 18 dBNo degradation in-band white noise
Physical specifications
Table 155 "Physical specifications" (page 365) outlines the physical
specifications of the NT5K21 XMFC/MFE circuit card.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 02.06 Standard
27 August 2008
Copyright © 2003-2008 Nortel Networks
.