Nortel Networks 1000 - Manual (Page 70)

70 Acceptance tests
LOGI (password)
2 Request the status of a loop on the conference card:
LD 38
STAT loop
Conference status is formatted as follows:
CNFC n DSBL n BUSY
"n" represents the number of conference groups disabled and
busy
CHAN n DSBL n BUSY
"n" represents the number of channels disabled and busy
UNEQ
card is not equipped in the system
DSBL card is disabled in software
3 If the conference card loop is disabled, enable it.
For an NT8D17 Conference/TDS card, enter:
ENLX loop
(the conference loop is the odd loop of the conference/TDS loop
pair)
Note: The conference/TDS card is not enabled automatically
when it is inserted. You must enable the card with the
command ENLX. (This command is used in LD 34 and LD 46
to address even loops and in LD 38 to address odd loops.)
Enabling the loops with the command ENLL does not enable
the hardware for the card.
For other than an NT8D17 Conference/TDS card, enter:
ENLL loop
(the conference loop must be an even loop for cards other than
the NT8D17)
If the system response is other than OK, seeSoftware
Input/Output Reference — Administration (NN43001-611) to
analyze the messages.
4 Test the conference loop for channel, group, and switching
faults:
CNFC loop
If the conference loop passes the tests, the output is OK .
If the system response is other than OK , see Software
Input/Output Reference — Administration (NN43001-611) to
analyze the messages.
5 Prepare the system for a manual conference call on a specified
loop:
CNFC MAN loop c
Where "c" is the manual conference group (1-15)
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 02.06 Standard
27 August 2008
Copyright © 2003-2008 Nortel Networks
.