Nortel Networks 1000 User Manual
Page 20
20
Overview
Figure 1
IPE line cards shown installed in an NT8D37 IPE module
When installing line cards, follow these general procedures:
Step
Action
1
Configure the jumpers and switches on the line card (if any) to
meet system needs.
2
Install the line card into the selected slot.
3
Install the cable that connects the backplane connector on the
IPE module to the module I/O panel.
4
Connect a 25-pair cable from the module I/O panel connector to
the Main Distribution Frame (MDF).
5
Connect the line card output to the selected terminal equipment
at the MDF.
6
Configure the individual line interface unit using the Analog
(500/2500-type) Telephone Administration program LD
10 for analog line interface units and Multi-line Telephone
Administration program LD 11 for digital line interface units.
--End--
Once these steps are complete, the terminal equipment is ready for use.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311
02.06
Standard
27 August 2008
Copyright © 2003-2008 Nortel Networks
.