Nortel Networks 1000 - Manual (Page 676)

676 NT8D15 E and M Trunk card
These can be specified for the Meridian 1 end (near-end), or for the CO or
other PBX end (far-end). Joint party control can also be specified for the
far-end.
Release control of a call made over a trunk is specified in LD 16.
Disconnect supervision is specified for each trunk group independently.
The two options available are EITHER or ORIGINATING party control.
These can be specified for the CS 1000 end (near-end), or for the CO or
other PBX end (far-end). Joint party control can also be specified for the
far-end.
Release control of a call made over a trunk is specified in the route data
block (LD 16). Disconnect supervision is specified for each trunk group
independently.
Only incoming trunks in idle ground start configuration can provide
disconnect supervision. For a list of prompts and responses and default
conditions see Software Input/Output Reference — Administration
(NN43001-611).
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 02.06 Standard
27 August 2008
Copyright © 2003-2008 Nortel Networks
.