GE Industrial Solutions EntelliPro ES - Manual (Page 10)

CHAPTER 1: INTR ODUCTION
1.2 EP OS MOTOR MANAGEMENT SYSTEM – INSTRUCTION MANUAL
1.1.1 Warnings, cautions, notes, and references
WARNING notices are used in this publication to emphasize that hazardous voltages, currents, or other conditions
that could cause personal injury exist in this equipment or may be associated with its use. Warning notices are also
used for situations in which inattention or lack of equipment knowledge could cause either personal injury or damage
to equipment.
CAUTION notices are used for situations in which equipment might be damaged if care is not taken.
NOTES call attention to information that is especially significant to understanding and operating the equipment . This
document is based on information available at the time of its publication. While efforts have been made to ensure
accuracy, the information contained herein does not cover all details or variations in hardware and software, nor
does it provide for every possible contingency in connection with installation, operation, and maintenance. Features
may be described herein that are not present in all hardware and software systems. GE Industrial Solutions assumes
no obligation of notice to holders of this document with respect to changes subsequently made.
GE Industrial Solutions makes no representation or warranty, expressed, implied, or statutory, with respect to, and
explosive environment.
ATEX sign is used to indicate mandatory settings and items for use of EntelliPro to protect motors in in potential
assumes no responsibility for the accuracy, completeness, sufficiency, or usefulness of the information contained
herein. No warrantees of merchantability or fitness for purpose shall apply.
References
For details of the Modbus RTU protocol, refer to PI-MBUS-300 Rev. J from Modicon/AEG Schneider Automation. For
details of RS-485 communications, refer to the EIA-485 standard.
Modbus RTU® is a registered trademark of AEG Schneider Automation. Modbus® is a registered trademark of
Modicon Inc.
For additional information on the EntelliPro CP3 and CP5 HMI, please refer to the Beijer Electronics H-T40 and H-T70
installation and operation manuals.
For details on Profibus standards, refer to IEC 61158.