GE Industrial Solutions EntelliPro ES - Manual (Page 149)

4.12 EP OS MOTOR MANAGEMENT SYSTEM – INSTRUCTION MANUAL
CHAPTER 4: COMMUNICATION
93 Reset Overload Current Warning
94 Reset External Supervision Warning
95 Reset Long Start Warning
96 Reset Typical Specific Warning
99 Reset Parameter Error
100 Reset Watchdog Error
101 Reset Timer Interrupt Error
102 Reset Current Measurement Ungauged Error
103 Reset NOV RAM EEPROM
104 Reset Current Measurement Error
105 Reset Start Atte,[t
106 Reset Thermistor Error
113 RESET Operation Hours
116 RESET Maximum Current
117 RESET Trip Current
119 RESET Overload Event Counter
120 CLEAR Analog Value Log
141 2 Set Analog Value Log Manual Trigger
142 Stop Analog Value Log
144 Clear Overload Accumulator
179 3 Read Real Time Clock Registers
180 Clear Event Log
181 4 Write Real Time Clock Registers
184 Set factory default parameters
Save parameters in memory
1: If the local-remote-off switch is set to OFF, and an OFF command is received from a remote source, it
will be ignored unless the lock switch is enabled.
2: When this command is issued, the manual trigger will occur. Input holding register 58 MUST be set to
manual for this command to have any effect .
3: Value will be available on holding registers.
4; This command writes the Real Time Clock values in holding registers 76 to 83 to the EntelliPro RTC.
Table 4-5: Operation Codes for Function Code 05
188 Allow parameterization in running mode
189 Stop parameterization in running mode
18 5