GE Industrial Solutions EntelliPro ES - Manual (Page 184)

CHAPTER 4: COMMUNICATION
EP OS MOTOR MANAGEMENT SY STEM – INSTRUCTION MANUAL 4.47
Size Telegram Name Description Default Bytes
2 * 8-bit
5
6
Reset Device Errors
BIT0 - Reserved
BIT1 - Reserved
BIT2 - Reset Parameter Error
BIT3 - Reset Watchdog Error
BIT4 - Reset Timer Interrupt Error
BIT5 - Reserved
BIT6 - Reset EEPROM Error
BIT7 - Reserved
BIT0 - Reset Start Attempt
BIT1 - Reset Thermistor Hardwire Error
BIT2- BIT7 - Reserved
Reset Device Errors
1 will reset the specific error
2
8-bit RESET Firmware
BIT0 - Reset operation hours (motor)
BIT1 - Reset switching cycle counter (motor)
BIT2 - Reserved
BIT3 - Reset Maximum Current
BIT4 - Reset Minimum Current
BIT5 - Reset time stamp
BIT6 - Reset Overload memory
BIT7 - Clear Analog Value Log
Reset Firmware Parameters
This command is required to re-start the log
1
8-bit FIRMWARERESET_1
BIT0 - Stop Analog Logging
BIT1 - Reset Contactors 41 Operations Counter
BIT2 - Reset Contactors 42 Operations Counter
BIT3 - Reset Contactors 43 Operations Counter
BIT4 - Reset Contactors 4 Operations Counter
BIT5 - Reset Thermistor trips Counter
BIT6 - Reset Ground Fault Sum Trip Counter
BIT7 - Reset Hours of non-operation (Motor stopped
hours)
1
B2702 Set Value Telegram 6
16-bit Parameter Select
1- Operation Hours
2- Switch Counter
3- Reserved
4- Reserved
5- Reserved
6- Reserved
7- Reserved
Added for ESS-DP V5
8 - Contactors 1 Operations Counter
9 - Contactors 2 Operations Counter
10 - Contactors 3 Operations Counter
11 - Contactors 4 Operations Counter
12 - Thermal Overload trips Counter (2-bytes only)
13 - Thermistor trips Counter (2-bytes only)
14 - Ground Fault Sum Trip Counter (2-bytes only)
15 - Hours of non-operation (Motor stopped hours)
Set the Operation Hours
Set the Switch Counter (for which contactor)
2
32-bit Set Value Set value to the specific parameter selected 4