GE Industrial Solutions EntelliPro ES - Manual (Page 183)

CHAPTER 4: COMMUNICATION
4.46 EP OS MOTOR MANAGEMENT SYSTEM – INSTRUCTION MANUAL
4.2.7.3 EntelliPro ES Cyclic Write Telegram Definitions
The following table shows the detailed write telegram descriptions.
Size Telegram Name Description N ote Bytes
B10008 Write Control Telegram 4
BE (Customer Logic)
BIT0 - Switch command ON1
BIT1 - Switch command ON2
BIT2 - Reserved
BIT3 - Reserved
BIT4 - Switch command OFF
BIT5 - Identification
BIT6 - Reserved
BIT7 - Reserved for Master not available
BIT8 - Switch command locked
BIT9 - SW-Operation mode switch Local
BIT10 - SW-Operation mode switch Remote
Reserved
Reserved
Setting this Bit to 1 will close contactor 41
Setting this Bit to 1 will close contactor 43
Free
Free
Setting this Bit to 1 will open contactor 41 and 43
Request to identify EntelliPro ES in a panel. Digital output must be mapped
Free
Free
Operation mode set to Local (any local devices - Profibus class2, Modbus and/or
hardwire) can control the contactors
Operation mode set to Remote (only the selected remove device can control the
contactors
4
B2701 Reset Telegram 8
2 * 8-bit
1
2
Reset Fault
BIT0 - Overload Failure
BIT1 - Phase Loss Failure
BIT2 - Ground Fault Failure
BIT3 - Unbalanced Load Failure
BIT4 - Thermistor Failure
BIT5 - Emergency stop Failure
BIT6 - Limit Switch Failure
BIT7 - Safety Circuit Failure
BIT0 - Main Circuit Failure
BIT1- Control Circuit Failure
BIT2 - Switch Position Failure
BIT3 - UnderLoad Current Failure
BIT4 - Over Load Current Failure
BIT5 - External Supervision Failure
BIT6 - Long Start Failure
BIT7 - Typical Specific Failure
Reset Fault
1 will reset specific fault
2
2 * 8-bit
3
4
Reset Warning
BIT0 - Overload Warning
BIT1 - Phase Loss Warning
BIT2 - Ground Fault Warning
BIT3 - Unbalanced Load Warning
BIT4 - Thermistor Warning
BIT5 - Emergency stop Warning
BIT6 - Limit Switch Warning
BIT7 - Safety Circuit Warning
BIT0 - Main Circuit Warning
BIT1- Control Circuit Warning
BIT2 - Switch Position Warning
BIT3 - UnderLoad Current Warning
BIT4 - Over Load Current Warning
BIT5 - External Supervision Warning
BIT6 - Long Start Warning
BIT7 - Typical Specific Warning
Reset Warning
1 will reset the specific warning
2