GE Industrial Solutions EntelliPro ES - Manual (Page 148)

EP OS MOTOR MANAGEMENT SY STEM – INSTRUCTION MANUAL 4.11
CHAPTER 4: COMMUNICATION
The following table shows the command that can be initiated using function code 05.
Operation Code Description
1 Contactor1 ON
2 Contactor2 ON
5 Contactors 1 & 2 OFF
6 Module Identification (request EntelliPro ES ID)
9 1 Lock Switch Command
10 Switch to Local mode
11 Switch to Reset mode
65 Reset Overload Failure
66 Reset Phase Loss Failure
67 Reset Ground Fault Failure
68 Reset Unbalanced Load Failure
69 Reset Thermistor Failure
70 Reset Emergency stop Failure
71 Reset Limit Switch Failure
72 Reset Safety Circuit Failure
73 Reset Main Circuit Failure
74 Reset Control Circuit Failure
75 Reset Switch Position Failure
76 Reset Under Load Current Failure
77 Reset Overload Current Failure
78 Reset External Supervision Failure
79 Reset Long Start Failure
80 Reset Typical Specific Failure
81 Reset Overload Warning
82 Reset Phase Loss Warning
83 Reset Ground Fault Warning
84 Reset Unbalanced Load Warning
85 Reset Thermistor Warning
86 Reset Emergency stop Warning
87 Reset Limit Switch Warning
88 Reset Safety Circuit Warning
89 Reset Main Circuit Warning
90 Reset Control Circuit Warning
91 Reset Contactor Feedback Warning
92 Reset Under Load Current Warning