GE Industrial Solutions EntelliPro ES - Manual (Page 140)

EP OS MOTOR MANAGEMENT SY STEM – INSTRUCTION MANUAL 4.3
CHAPTER 4: COMMUNICATION
4.1.2 Modbus baud rate and port configuration
The EntelliPro supports the configured baud rate settings listed in Table 4-1, which can be set in WinESG
parameterization/Modbus setting panel shown In Illustration below or Modbus function code 6 register 90.
The EntelliPro supports the configured baud rate settings listed in Table 4-1, which can be set via communications.
The first number is the baud rate (300–19,200), the first digit after the dash is the number of data bits (fixed at 8), the
letter represents the parity setting (N = none, E = even, O = odd), and the last digit is the stop bit .
Modbus
connection
Address Switch
Figure 4-1: EntelliPro ES address switch settings and connection.