GE Industrial Solutions EntelliPro ES - Manual (Page 222)

CHAPTER 5: WinESG
EP OS MOTOR MANAGEMENT SYSTEM – INSTRUCTION MANUAL 5.2 6
5.3.2.10 Parameterization Cyclic panel
The cyclic panel enables the customer to select parameters to be viewed over Profibus class 1 master. Refer to Figure
5-16 for the WinESG parameterization cyclic communication panel.
Figure 5-16: WinESG parameterization cyclic panel
Figure 5-17: WinESG parameterization Modbus setting panel
5.3.2.11 Parameterization Modbus setting panel
The Modbus panel provides a means for selecting software or hardware Modbus address. If a software address is
selected, it can be entered in the Modbus panel. If a hardware address is selected, the EntelliPro ES uses the front
switches. In addition the appropriate baud rate, data bits, parity and stop bits can be set. Refer to Figure 5-17 for t
h
switch 1, Limit switch 2, General device error, Feedback identification, profibus class 1 failure, Modbus failure, Switching
Contactor 1 feedback, Contactor 2 feedback, Parameter mode, Switch protected, Star attempt, Drawer ready, General
Limit switch warning, Safety circuit warning, Main voltage warning, Contactor feedback warning, Under current warning,
Unbalalanced load failure, Thermistor channel failure, Emergency OFF failure, Limit switch failure, Safety circuit failure,
Over current warning, External supervision warning.
Overload warning, Phase loss warning, Ground fault warning, Unbalalanced load warning, Emergency OFF warning,
phase, Run phase, Thermistor line broken, Thermistor line, Overload failure, Phase loss failure, Ground fault failure,
1 in progress, Switching 2 in progress, Breaker tripped 2, Breaker charged, Torque switching 1, Torque switching 2, Start
Main voltage failure, Contactor feedback failure, Under current failure, Over current failure, External supervision failure,
warning, General Fault, Safety circuit, Local mode, Remote mode, Drawer operational mode, Drawer test mode, Limit
The following parameters status can be mapped to the Dynamic status data block:
e
WinESG parameterization Modbus panel.