GE Industrial Solutions EntelliPro ES - Manual (Page 241)

6.2 EntelliPro CP3 application setting
Screen “Settings 2” shows the application version number, the current Modbus address , and the current Modbus timeout time
in seconds.
This timeout
value can be set in the EntelliPro ES device. This value is shown if the Modbus communication is connected.
To establish a communication between the EntelliPro CP and the EntelliPro ES, the Modbus address must set to the same
Modbus address as in EntelliPro ES device. To change the address, click on the Modbus address number.
COM 1
12
Button to switch into the
Modbus RTU setting.
Modbus timeout setting,
read from EntelliPro ES
device
Version number of the
EntelliPro CP3 application.
Menu name.
6.6 EPOS MOTOR MANAGEMENT SYSTEM – INSTRUCTION MANUAL
CHAPTER 6: ENTELLIPRO CP3 and CP5 APPLICATION