GE Industrial Solutions EntelliPro ES - Manual (Page 204)

CHAPTER 5: WinESG
EP OS MOTOR MANAGEMENT SYSTEM – INSTRUCTION MANUAL 5. 8
CAUTION: A change of maximum data record in an existing alarm protocol trace causes a break in the serial number of
the entries in the database.
5.2.2 Access protection panel
In the Access protection panel, shown in the illustration below, user can set login settings, password and prevent
unauthorized access. If you start the WinESG for the first time and no user with administrator rights is defined, the
message ”The user protection is to be defined“ is displayed. In this state you can log in as administrator with the user
name ”GEPC“ and the password ”EPOS“.
Change current access mode: access mode can be changed when the login name and password are entered.
Time: if Enable Protection is selected, the WinESG will switch to viewing mode after this time expires.
Add user: user can be entered and the access protection defined, shown in the illustration below.
Two groups name can be defined:
Administrator: full access rights: WinESG function, editing the user list, activate or deactivate the enable
protection and time.
Control: with limit access rights: WinESG function, and the right to change the password.
WinESG functions are defined as: closing WinESG, changing database, changing alarm protocol settings, saving parameters,
copying parameters, device configuration, control commands, reset of diagnostic and measuring values.