GE Industrial Solutions EntelliPro ES - Manual (Page 12)

CHAPTER 1: INTR ODUCTION
1.4 EP OS MOTOR MANAGEMENT SYSTEM – INSTRUCTION MANUAL
1.1.3 Description of the EntelliPro ES Motor Control Module
The EntelliPro ES is used in conjunction with CTs in branch-drawout systems. This system consists of LEDs, fuses,
contactors, and additional components required for the control and switching of the branch. The EntelliPro ES
includes the following input/output capabilities:
 Seven to sixteen inputs, depending on the catalog type
 Three to eight outputs, depending on the catalog type
The following additional functions are available:
 Overload protection
 Thermistor protection
 4–20 mA output sensing
 EntelliPro ES alarm modules configurable for fault (trip) or warning (alarm)
 Eleven predefined starter types
 Six predefined controls
 Start inhibits
 Restart timer
 Number of starts
 Number of contactor closures (each relay has its own counter)
 Operating hours
 Non-operating hours
 Counters for overload, ground fault , and thermistor faults
 Time stamp event
 Time stamp analog value
The thermal model uses motor protection curves according to IEC 60947 (IEC Class 5 to 40) and incorporates hot/cold
biasing, unbalance biasing, and exponential cooling.
Figure 1-1 shows an example of a single-line system for EntelliPro ES3 and ES5.