GE Industrial Solutions EntelliPro ES - Manual (Page 206)

CHAPTER 5: WinESG
EP OS MOTOR MANAGEMENT SYSTEM – INSTRUCTION MANUAL 5. 10
5.3 Windows menu
The Windows menu contains eight sub-menus: Control, Parameterizing, Char (characteristic), Diagnostic, Measure,
Alarms, Debug, and Analog data capture, shown in figure 5.4.
Figure 5-4: WinESG windows menu panel options
5.3.1 Control Panel
The control panel gives the user the ability to view the status of the EntelliPro ES, contactors and drawer and to control
the motor operation.
Refer to Figure 5-5 for the WinESG control panel contactor operation.
The first row indicates the number of the bus line, bus address and device identification text.
In the next line the drive status is show n as symbol and as text:
Red Symbol = motor ON
Green Symbol = motor OFF
Next line is the control buttons:
ON 2 is used for two-speed motors. For direct starters this button has no meaning.
Pressing these buttons, commands are sent to the device, independently of its status. Whether the control command is
accepted or not depends on the logic program of the EntelliPro ES.
If the device identification box is checked and the output is mapped to identification the respective relay will close.
Refer to Figure 5-5 for the WinESG control panel contactor operation.
ON1
ON2
OFF