Spectra Precision ProFlex 800 Reference Manual - Manual (Page 107)

93
Using the Web Server
• Click on the Configure button to let the Web Server load all
your new parameters to the receiver.
Configuration Memo
Entering the settings of a base/rover system is quite
straightforward when a radio is used to transmit corrections
from the base to the rover.
When an IP connection is used, understanding the possible
base/rover associations is not so clear because in addition,
you have to take account of the server-client requirement
inherent in any IP connection.
The diagrams below should help you keep in mind which
associations are possible when using an IP connection
(through GPRS modem or Ethernet port).
• [1]: Base, “NTRIP server” via Ethernet
• [2]: Base, “NTRIP server” via modem
• [3]: Base, Ethernet data streaming
• [4]: Base, Direct IP client via modem
• [5]:Base, Direct IP client via Ethernet
• [6]: Rover, NTRIP client via Ethernet
• [7]: Rover, NTRIP client via modem
• [8]: Rover, Direct IP client via modem
• [9]: Rover, Direct IP client via Ethernet
• [10]: Base, 2 NTRIP servers + embedded NTRIP caster