Spectra Precision ProFlex 800 Reference Manual - Manual (Page 375)

361
Set Command Library
Parameters
Example
Enabling the use of the DynDNS service, for a receiver
accessible through hostname “ashtech1”:
$PASHS,DDN,PAR,DYN,1,SYS,[email protected],USR,psmith,PWD,as
htech,HNM,ashtech1.dyndns.org,PER,600*0C
Comment
• After running this command with d1=1 to enable the
service, the receiver will try to connect to the service. If
the connection is successful, the receiver will return
$PASHR,DDN,OK. If it fails, the receiver will return
$PASHR,DDN,FAIL, causing d1 to be reset to “0”.
• Running commands $PASHS,RST and $PASHS,INI will
reset d1 to 0 but will keep all other parameters
unchanged.
Relevant Query
Command
$PASHQ,PAR
$PASHQ,DDN
See Also $PASHS,ETH,PAR
$PASHS,DDN,SET
Parameter Description Range Default
DYN,d1
Enabling/disabling the use of
the service:
• 0: Enable
• 1: Disable
0, 1 0
SYS,s2 Address of the service used.
100 characters
max. dyndns@dyn
dns.org
USR,s3
Username you chose when
creating your personal account
on the DynDNS web site.
32 characters
max.
-
PWD,s4
Password you chose when cre-
ating your personal account on
the DynDNS web site.
32 characters
max.
-
HNM,s5
Hostname you declared on the
DynDNS web site for the
receiver.
100 characters
max.
-
PER,d6 Update rate, in seconds 60-3600 600
*cc Optional checksum *00-*FF