Spectra Precision ProFlex 800 Reference Manual - Manual (Page 342)

328
Set Command Library
$PASHS,BDS,RT2,I1,OFF*OF
Relevant Query
Command
$PASHQ,BDS
See Also $PASHS,DST
$PASHS,RTC,TYP
$PASHS,ATD,TYP
BEEP: Beeper Setup
Function This command enables or disables the internal beeper.
Command Format Syntax
$PASHS,BEEP,s1[,d2][*cc]
Parameters
Example
Disabling the beeper:
$PASHS,BEEP,OFF*04
Relevant Query
Command
$PASHQ,BEEP
BRD: Enabling/Disabling the RTC Bridge Function
Function This command is used to control the RTC Bridge function. Its
use is required only in the receiver in charge of forwarding its
Parameter Description Range Default
s1 Enables (ON) or disables (OFF) the beeper. ON, OFF ON
d2
Timeout, in seconds:
• 0: No timeout. If an alarm is activated, the
beeper will sound indefinitely until the
alarm is acknowledged.
• >0: If an alarm is activated, the beeper
will sound only for a limited period of time
(it will go out automatically at the end of
the specified timeout).
0-99 30
*cc Optional checksum *00-*FF