Spectra Precision ProFlex 800 Reference Manual - Manual (Page 39)

25
Receiver Description
• Plug the adapter into an AC outlet. Battery charging starts
immediately.
For a low battery that’s being charged, you will first see the
three LEDs switch on and off, one after the other, followed
by a short period of time when none of the LEDs is on (see
[3]).
After about two hours of charging, the MED LED will stay
on [4]. A few minutes later, the HI LED [5], and then the
MAX LED [6] will also stay on.
• When the three LEDs are on, this means the battery is
fully charged and can be disconnected from the charger.
Inserting the
Battery in the
ProFlex 800
• Insert the battery into the compartment making sure the
battery has the right orientation (the battery terminals
should come into contact with the two sets of connectors
located at the bottom of the compartment).
• Close the trapdoor, push the finger screw in tight, and turn
it fully clockwise.
Note that once it is properly secured, the trapdoor pushes
the battery against the bottom of the compartment to
ensure electrical connection of the battery to the ProFlex
800.
[1] [2]
1 1
2
MED MAX HI
MED MAX HI
[3]
[6]
MED MAX HI
[5]
MED MAX HI
[4]