Spectra Precision ProFlex 800 Reference Manual - Manual (Page 35)

21
Receiver Description
• Fourth line: Squelch setting (medium, low, high). Extra-
parameters for Rx if a Pacific Crest: “FEC” if forward error
correction enabled, “SCR” if scrambling enabled.
Modulation type (GMSK, 4FSK). The fourth line will be
slowly scrolled to the right if four parameters have to be
displayed in the line.
ATL Recording
Screen
Pressing the Scroll button from the Position Computation
screen –or from the Radio Settings screen if there is a radio
used– will take you to the ATL Recording screen, which looks
like one of the following, depending on whether a USB key is
connected to the receiver (below, right) or not (below, left).
You don’t normally have to record ATL data, but if for
troubleshooting purposes, the Technical Support asks you to
do so, then proceed as follows:
• Press the Log button (left-hand button). This will cause
the receiver to start recording ATL data on the specified
storage medium. The screen will then look like this:
You can then freely use the Scroll button to access other
receiver screens without affecting the ATL data collection
in progress (pressing the Scroll button from this screen
will take you back to the General Status screen).
• When enough ATL data have been recorded (Tech Support
will usually indicate the duration of ATL data collection
needed for troubleshooting), then come back to the ATL
Recording screen and simply press on the Log button
again to stop the recording.
NOTE 1: ATL data recording is totally independent of raw
data recording: controlling ATL recording is done exclusively
from the ATL recording screen, and raw data recording from
any other screen.