Ant: antenna height, Function, Command format – Spectra Precision ProFlex 800 Reference Manual User Manual
Page 332
Advertising
318
Set Command Library
$PASHS,ANT
ANT: Antenna Height
Function
This command is used to define the antenna height,
especially when it was determined using the slant
measurement method. However, a vertical measurement can
also be entered through this command.
Using the $PASHS,ANT command overwrites all previous
settings performed with the $PASHS,ANH command.
Command Format
Syntax
$PASHS,ANT,f1,f2,f3[*cc]
Diagrams and Definitions
• ARP: Antenna Reference Point (usually bottom of the
antenna).
• SHMP: Slant Height Measurement Point (usually at the
hedge of the antenna, above the ARP).
• Ground Mark (GM): above the ARP (same horizontal
coordinates).
f3
Slant Measurement
Vertical Measurement
ARP
f2
f3
SHMP
GM
GM
f1
Advertising