Spectra Precision ProFlex 800 Reference Manual - Manual (Page 93)

79
Using the Web Server
Enable Connect Now to allow the receiver to establish the
connection right after you have clicked on Configure.
• In the corresponding Differential Stream x pane, choose
Port= “P - Ethernet” as the output port delivering the
generated differential data. In the
Message field, choose
the type of differential message provided through this port
(ATOM, RTCM, CMR, CMR+ or DBEN).
NOTE: The receiver has been designed to offer two
separate and independent differential data outputs. Each
one can output a specific type of differential message. If
only one output is used, select
Port=“None” for the other
output.
• Click on the Configure button to let the Web Server load all
your new parameters to the receiver. You have now
reached the end of the configuration phase.
NTRIP Server Via
Modem
CAREFUL: In the RTCM sense, an “NTRIP server” is a source
of corrections feeding an NTRIP caster (see RTCM paper
200-2004/SC104-ST). But from the point of view of the
network terminology, an “NTRIP server” is a client, not a
server.
The internal modem should be configured first:
• Click on the Connections menu and then on the Bluetooth/
Modem sub-menu.
• Set the following parameters in the Internal Modem/Device
Settings pane:
–
Power: Select “On”. Then choose whether the modem
should be turned on automatically or manually:
Automatic: The modem will be switched on or off
automatically when the rover is respectively turned on
or off.
Manual: The modem will be powered up only by going
through the
Connections > Bluetooth/Modem page and
Modem
ProFlex 800
(Mobile Wireless
Communication)
Internet
(Client)
IP address
or server name
NTRIP Caster
Users